Remedy: 1 Visually check the CR scanning section Is there no paper jam paper and foreign object in the CR scanning section?.Contact damage (contact failure)/disconnection/half insertion of CR Encoder FFC.High sliding load (oil cutoff, paper dust, mist).CR Lock Lever failure (Inksystem Assy failure).Jammed paper or foreign object remained.When rotated in the opposite direction to rotation direction (There was a sudden load error, and the motor rotated in the opposite direction in reaction to it).State in which load of CR Motor exceeds expected load.

Does the error occur after replacing the Main Board Assy?

Replace the CR Motor if the motor cable is disconnected.Ģ Replace the Main Board Assy.

Check the CR Motor cable to make sure that there is no error (disconnection/ contact failure).

Remedy: 1 Visually check the CR Motor cable.

CR Motor cable disconnection or contact failure.

If you find you get errors on a regular basis, you can find further help in our guide to potential causes of data corruption.The driving time of the motor exceeded the set time. This appears when there are some manual steps needed to fix your data. For further help with this window, read more >Īlthough not as serious, it's also good practice to fix any warnings or comments, visit .uk/mydata, find the relevant warning or comment and follow the steps on the linked article.Įrrors in your data shouldn't happen very often. This appears when your errors are unrepairable. For further help with this window, read more > For further help with this window, read more > This window appears if the errors may be fixed automatically. Depending on the errors you have, in the File Maintenance Problems Report you see one of the following three windows:

Some errors can be fixed automatically in your software and some may need additional action by you in order to be fixed. Any corruption banner or messages on start-up will disappear after your next scheduled backup. If your File Maintenance Problems Report shows no errors at this point, your data is fixed and you can continue as normal. TIP: In Sage 50cloud Accounts v28, when you click Run repair an automatic repair is ran. To fix any errors that appear, proceed to the next section. Comments - these are for information only, we recommend you check these from time to time.Warnings - we recommend you fix these before continuing.Errors - you must stop processing until they have been resolved and no longer appear.Īny issues with your data are listed on the File Maintenance Problems Report as errors, warnings or comments: Click File, click Maintenance and click Check Data.Īlternatively, i f you see one of the messages above, c lick Run repair or Check data and view errors.If you're already logged into your company, to check your data:

Sage payments error codes 000043